INSTALLATION | ||
|
|
|
2.Proper support of, and attachment to, the base of the welding equipment so there will be no undue stress to the framework.
3.Proper placement of the equipment on the trailer to ensure stability side to side and front to back when being moved and when standing by itself while being operated or serviced.
4.Typical conditions of use, i.e., travel speed, rough- ness of surface on which the trailer will be operat- ed; environmental conditions, likely maintenance.
5.Conformance with federal, state and local laws. (1)
(1)Consult your federal, state and local laws regarding specific requirements for use on public highways.
VEhICLE MOuNTING
WARNING
Improperly mounted concentrated loads may cause unstable vehicle handling and tires or other components to fail.
•Only transport this Equipment on serviceable vehicles which are rated and designed for such loads.
•Distribute, balance and secure loads so vehicle is stable under conditions of use.
•Do not exceed maximum rated loads for compo- nents such as suspension, axles and tires.
•use appropriate nuts bolts and lockwashers to attach the equipment base to the metal bed or frame of vehicle.
•Follow vehicle manufacturer’s instructions.
POLARITY CONTROL AND CAbLE SIzES
With the engine off, route the electrode and work cables through the strain relief bracket on the base and connect to the studs located below the fuel tank mounting rail. (See size recommendations below.) For positive polarity, connect the electrode cable to the terminal marked “+”. For Negative polarity, con- nect the electrode cable to the
When welding at a considerable distance from the welder, be sure you use ample sized welding cables.
RECOMMENDED COPPER CAbLE SIzES
|
| Cables Sizes for Combined Length | ||
|
| of Electrode Plus Work Cable | ||
|
|
|
| |
Amps | Duty Cycle | up to 200ft.(61m) | 200 to 250ft. | |
|
|
| (61 to 76m) | |
250 | 100% | 1 | 1/0 |
|
|
|
|
|
|
300 | 60% | 1/0 | 2/0 |
|
|
|
|
|
|
PRE-OPERATION SERVICE
CAuTION
READ the engine operating and maintenance instructions supplied with this machine.
WARNING
•Stop engine while fueling.
•Do not smoke when fueling.
•Keep sparks and flame away from tank.
•Do not leave unattended while fueling.
• Wipe up spilled fuel and allow fumes to clear before starting engine.
• Do not overfill tank, fuel expan-
sion may cause overflow.
DIESEL FuEL
OIL
This unit is supplied from the factory with the engine crankcase filled with a high quality SAE 10W/30 oil. This oil should be acceptable for most typical ambient temperatures. Consult the engine operation manual for specific engine manufacturer’s recommendations. Upon receipt of the welder, check the engine dipstick to be sure the oil is at the “full” mark. DO NOT overfill.
FuEL
Fill the fuel tank with the grade of fuel recommended in the Engine Operator’s manual. Make sure the fuel valve on the water separator is in the open position.
COOLING SYSTEM
The radiator has been filled at the factory with a
