Lindy 32416 manual Switching Via Ethernet, Configuration, Logout, Reset

3. SWITCHING VIA ETHERNET

Login to the website of the IPower Control, http:// “IP Address of IPower Control” (e.g. 192.168.0.2). You may need to enter a password (see section 6). Now you can choose a port in order to reset it or switch it directly.

The following options are available:

Configuration

The settings of the IPower Control and the single ports can be configured here (see section 4 below)

Logout

Only one user can be logged in at a time. After three minutes inactivity there will be an automatic log out.

Having chosen a port it can be switched or reset.

Reset

Independently of the current switching state, the port will be switched on after the chosen delay, i.e. the connected device will be turned on.

4. CONFIGURATION

Via the website of the IPower Control, you can access the configuration menu. To modify the settings of a port, choose it from the roll-up menu in the upper part of the configuration menu (Port Configuration, section 5). The IPower Control settings can be modified in the lower part of the menu (Network Configuration, section 6).

Modifications to name and password will be applied immediately. To apply modifications to other settings, the IPower Control must be restarted.