User Manual | English |
Hardware Assembly
Before starting the assembly make sure the jumper(s) on your hard drive are set to the Master setting. Consult your hard disk manual or the manufacturer’s website for the correct jumper setting.
1.Ensure that the NAS Enclosure is disconnected from the mains, before removing the 4 screws from the bottom of the case
2.Remove the upper case
3.If you are using a SATA hard drive continue to Step 4, if you are using an IDE hard drive please skip to Step 5.
4.Connect the SATA Data and SATA Power cables to the relevant connector on your hard drive and continue to Step 12
5.Before you can connect your IDE hard drive you must first remove the SATA Bridge Board and Molex to SATA power cable.
6.Carefully disconnect the 4 pin power connector, by holding the base of the drive enclosure and pulling the connector away from the bridgeboard.
2
