Hotkey Sequence
‘HOTKEYs’ & 0
‘HOTKEYs’ & $
‘HOTKEYs’ & /
‘HOTKEYs’ & 2
then {number} (where {number} is 0, 1, 2, 3, 4, 5, 6, 7, 8 or 9).
CPU 4 OSD, 8 OSD and 16 OSD Only
Displays the on screen menu for selecting
computers by name
Selects autoscan mode where each channel is displayed for the selected time (see section 4.4). To cancel autoscan mode simply select any fixed channel either by hotkey or using the LINDY CPU Switch button.
Disables the LINDY CPU Switch 's shared keyboard and mouse and displays 0. The video signal is switched off. If a password has not been set then the LINDY CPU Switch can be re- enabled by selecting a channel. If a password has been set then the LINDY CPU Switch displays 'P' to indicate that a valid password must be entered to unlock the switch. Simply type the same key combination as was set during configuration (see section 4.9) then press the <ENTER> key. Note - if anyone has typed at the keyboard whilst in secure mode, it will be necessary to press the <ENTER> key first to clear the invalid password, then type the valid password followed by pressing <ENTER> again.
Selects the channel specified by {number}. This allows ports on cascaded units to be selected. For example hotkeys + 010216 would select port 1 (01) on the current LINDY CPU Switch, port 2 (02) on the next cascaded LINDY CPU Switch and port 16 on the last LINDY CPU Switch.
Examples of common hotkey sequences (assuming t+ shotkey option):
To select channel 2: press tsrelease ts
To 'tab through' channels: press tsvrelease vpress v
Release vpress vrelease vts
To select channel 15 (on a CPU 16 OSD):
press tsrelease press release ts
LINDY ELECTRONICS LTD | Installation & Use – English Guide | Page 19 |
