User’s Guide | Link electronic Wireless 802.11g AP Router guide

frame. After receiving an RTS, the wireless station responds with a Clear to Send (CTS) frame to acknowledge the right to begin transmission.

Fragmentation Threshold: This value specifies the maximum size for a packet before data is fragmented into multiple packets. It should remain at its default setting of 2346. If you experience a high packet error rate, you may slightly increase the Fragmentation Threshold. Setting the Fragmentation Threshold too low may result in poor network performance. Only minor modifications of this value are recommended.

AP Mode or Wireless Bridge Mode: 802.11g AP Router can operate in two modes. When the AP Mode is selected, the device operates as a normal Access Point. Proving every wireless client station a join network point.

The Wireless Bridge Mode will be able to join different AP Router wirelessly by input the destination MAC Address.

* Click Apply to save your settings.

User’s Guide

23

Image 24

Link electronic Wireless 802.11g AP Router user manual User’s Guide

Contents

Wireless 802.11g AP Router Copyright Statement Contents Introduction Safety Notification Hardware Installation PWR/STAT Web Management Settings Turn on Power Supply Primary Setup Make Correct Network Settings of Your Computer Dynamic IP Setting Static IP Address ∙ Default Gateway∙ User Name and Password Internet IP Address and Subnet Mask User’s Guide WPA-Preshared key AlgorithmsWPA Shared Key Please input the Authentication port of your Radius server Server Port Default port being used isRadius server will accept the authentication if both Please choose your algorithms method. You can select Security User’s Guide To upgrade the Router’s firmware System For Windows 98 and Millennium Click More Info User’s Guide Dhcp Server 192.168.1.100 User’s Guide Snmp Status Advanced Wireless Authentication Type User’s Guide Access Filters Internet Access Policy To create or edit a policy, follow these instructions Summary Virtual Server User’s Guide Enable Port Triggering Routing Table Dynamic RoutingStatic Routing, Destination Delete This Entry Click the Delete This Entry button Click the Show Routing TableShow Routing Table Dynamic DNS DynDNS.org Troubleshooting My Wireless AP Router will not turn on. No LED’s light upLAN Connection Problems I can’t access my AP Router Basic Functions User’s Guide