The WANIndicators
Link Green. The Link LEDilluminates when a successful con-
nection is made between the Router and your Broadband
device or network.
Act Green. The Act LEDflickers when the Router is sending or
receiving data over the broadband port.
Diag Red. The Diag LED illuminates when the Router goes
through its self-diagnosis mode during boot-up. It will turn
off upon successful completion of the diagnosis. If this
LED stays on for an abnormally long period of time, refer
to the Troubleshooting section.
EtherFast® Cable/DSL & Voice Router powered by Net2Phone
7
Instant BroadbandTM Series
The Cable/DSL Voice Router’s Front Panel LEDs
The LAN Indicators
Net2Phone
In Use Green. The Net2Phone LEDilluminates when there is an
open phone connection.
Power Green. The Power LEDilluminates when the Router is pow-
ered on.
Link/Act Green. The Link/Act LED serves two purposes. If the LED
is continuously illuminated, the Router is successfully con-
nected to a device through the corresponding port (1, 2, 3
or 4). If the LED is flickering, the Router is actively send-
ing or receiving data over that port.
Full/Col Green. The Full/Col LED also serves two purposes. If this
LED is continuously illuminated, the connection made
through the corresponding port is successfully running in
Full Duplex mode. If the LEDis flickering, the connection
is experiencing collisions. Infrequent collisions are normal.
If this LED is flickering too often, there may be a problem
with your connection. Check the Troubleshooting section if
you think there is a problem.
100 Orange. The 100 LED illuminates when a successful
100Mbps connection is made through the corresponding
port.
6