![](/images/new-backgrounds/1122420/122420123x1.webp)
10/100 |
|
Phase2 Enc/Auth/Grp. This shows the Phase 2 Encryption type (DES/3DES), Authentication method (MD5/SHA1), |
|
and DH Group number (1/2/5) that you chose in the IPSec Setup section. |
|
If you selected Manual Keying Mode in the IPSec Setup section, then there is no Phase 2 DH Group, so only the |
|
Encryption type and Authentication method will be displayed. |
|
Local Group. This shows the IP address and subnet mask of the Local Group. |
|
Remote Group. The IP address and subnet mask of the Remote Group are displayed here. |
|
Remote Gateway. It shows the IP address of the Remote Gateway. |
|
Tunnel Test. Click the Connect button to verify the status of the VPN tunnel. The test result will be updated in the |
|
Status column. If the tunnel is connected, a Disconnect button will be available so you can terminate the VPN |
|
connection. (If you selected Manual Keying Mode in the IPSec Setup section, the Tunnel Test will not be available.) |
|
Config. Click the Edit button to open a new screen where you can change the tunnel’s settings. Refer to the |
|
Gateway to Gateway or Gateway to Client section for more information. Click the Trash Can icon to delete all of |
|
your tunnel settings for each individual tunnel. |
|
Tunnel(s) Enabled and Tunnel(s) Defined. These |
|
and number of VPN tunnels that are defined. The number of tunnels enabled may be fewer than the number of |
|
tunnels defined because you can disable any of the tunnels that you have defined. |
|
GroupVPN Status |
|
If you did not enable any Group VPN connections, then none will be listed in the GroupVPN table. |
|
Group Name. It shows the name you gave the Group VPN on the Client to Gateway screen. |
|
Connected Tunnels. This shows the number of connected tunnels. |
|
Phase2 Enc/Auth/Grp. This shows the Phase 2 Encryption type (DES/3DES), Authentication method (MD5/SHA1), |
|
and DH Group number (1/2/5) that you chose in the IPSec Setup section. |
|
Local Group. This shows the IP address and subnet mask of the Local Group. |
|
Remote Client. The remote client setup that you’ve chosen will be displayed here. |
|
Remote Client Status. If you click the Detail List button, you will see information about this Group VPN. You can |
|
view its Group Name, IP address, and Connection Time. Click the Refresh button to update the status information. |
|
Click the Close button to exit this screen. | Figure |
| |
Chapter 6: Setting up and Configuring the Router | 51 |
VPN Tab - Summary