Linksys WAP300N
How to use Access Point mode
In addition to the topics below, see the topics “How to set up the MAC filter” on page 19 and “How to set up QoS (Quality of Service)” on page 20.
How to select Access Point mode
To select Access Point mode:
Setup > Operation Mode
1.Log into the
2.Click the Setup tab, then click the Operation Mode page.
3.Select Access Point (default), then click Save Settings.
How to use Wi-Fi Protected Setup
While in Access Point mode, you can use
You can use three methods for
••Press the
••Enter the client device’s
••Enter the WAP300N’s
To manually configure your network, see “How to manually set up your WAP300N” on page 10).
Setting Up: Basics
NOTE
Your WAP300N must have
How to connect a device using the
Use this method if your device has a
To connect a device using the Wi-Fi Protected Setup button:
1.Press the
2.Within two minutes, press the
- OR -
a.Log into the WAP300N’s
b.Click the Wireless tab, then click the Basic Wireless Settings page.
c.For Configuration View, select
d.Click the
9
