Wireless-G Exterior Access Point

To link your wired network with your wireless network, connect the Access Point’s Ethernet network port to any switch or router with Power over Ethernet (PoE)—or a PoE injector, such as the Linksys WAPPOE or WAPPOE12. Note that 12 VDC on WAPPOE12 is for the splitter output. Both PoE Injectors provide 48 VDC power output.

With these and many other Linksys products, your networking options are limitless. Go to the Linksys website at

www.linksys.com for more information about wireless products.

Example of a Simple Wireless Network

Figure 2-1: Example of a Simple Wireless Network

The above diagram shows a typical infrastructure wireless network setup. The Wireless Access Points are connecting to a Linksys switch that provides power to the Access Points. Each Access Point can connect multiple wireless devices to the network. This network will provide connectivity among wireless network devices and PCs that have a wired connection to the switch.

The switch then can connect to a router that can connect to an ISP to reach global Internet.

Chapter 2: Planning Your Wireless Network

5

Example of a Simple Wireless Network

Page 11
Image 11
Linksys WAP54GPE manual Example of a Simple Wireless Network