Wireless-G Exterior Access Point

Device Name. Enter the name you wish to give to the Access Point.

Location. Enter the location of the Access Point.

Get Community. Enter the password that allows read-only access to the Access Point’s SNMP information. The default is public.

Set Community. Enter the password that allows read/write access to the Access Point’s SNMP information. The default is private.

SNMP Trap-Community. Enter the password required by the remote host computer that will receive trap messages or notices sent by the Access Point.

SNMP Trusted Host. You can restrict access to the Access Point’s SNMP information by IP address. Enter the IP address in the field provided. If this field is left blank, then access is permitted from any IP address.

SNMP Trap-Destination. Enter the IP address of the remote host computer that will receive the trap messages.

Change these settings as described here and click Save Settings to apply your changes, or click Cancel

Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click

More for additional details.

Chapter 6: Configuring the Wireless-G Exterior Access Point

33

The Administration - Management Tab

Page 39
Image 39
Linksys WAP54GPE manual Wireless-G Exterior Access Point