Wireless-G Bridge for Phone Adapters

5.Connect the power jack to the Power port of the Bridge. Then plug the power adapter into an electrical outlet. Click Next to proceed with the installation process, or click Back to return to the previous screen.

6.You will use the combination Ethernet network and power cable attached to the Bridge. Connect the Ethernet network cable of the Bridge to an Ethernet network (LAN) port of the router or PC. (Do not use the power cable now; you will use it later.)

NOTE: If you connect the Bridge to a router, make sure the Bridge and PC running the Setup Wizard are connected to the Ethernet network (LAN) ports of the same router.

Make sure the Bridge’s Ethernet LED is solidly lit or flashing.

Click Next to proceed, or click Back to return to the previous screen.

Chapter 4: Setting Up and Connecting the Wireless-G Bridge for Phone Adapters

Figure 4-5: Power on the Bridge Screen

Figure 4-6: Connecting the Network Cable to a

Router Screen

9

Running the Setup Wizard

Page 15
Image 15
Linksys WBP54G V2 manual Power on the Bridge Screen