Wireless-G Presentation Player

Chapter 3: Getting to Know the Presentation Player

Overview

This chapter describes what is on the back and front panels of the Presentation Player, and the remote control.

The Back Panel

The Presentation Player's ports, where a network cable is connected, and the reset button are located on the back panel. See Figure 3-1.

USB

The USB port is where you will connect the USB memory disk device.

Monitor/Projector

The Monitor/Projector port is where you will connect the VGA cable from the monitor or

 

projector where your presentation will be displayed.

LAN

This LAN (Local Area Network) port connects to Ethernet network devices, such as a

 

switch or router.

Power

The Power port is where you will connect the power adapter.

Reset Button

There are two ways to reset the Presentation Player's factory defaults. Either press the

 

Reset Button, for approximately ten seconds, or restore the defaults from the

 

Administration tab in the Presentation Player's Web-based Utility.

With these, and many other, Linksys products, your networking options are limitless. Go to the Linksys website at

www.linksys.com for more information about products that work with the Presentation Player.

Important: Resetting the Presentation Player will erase all of your settings (WEP Encryption, Wireless and LAN settings, etc.) and replace them with the factory default settings. Do not reset the Presentation Player if you want to retain these settings.

Figure 3-1: Back Panel

Chapter 3: Getting to Know the Presentation Player

6

Overview

Page 12
Image 12
Linksys WPG54G manual Getting to Know the Presentation Player, Overview, Back Panel