Logitech Duet manual Set Up the Hardware, Charge the Battery

Models: Duet

1 45
Download 45 pages 49.78 Kb
Page 8
Image 8

SqueezeboxDuet User Guide

7

 

 

Set Up the Hardware

Charge the Battery

For this step you’ll need:

Squeezebox Controller

Charging cradle with AC adapter

Plug adapter for your region

Battery

You’ll start the installation process by charging the battery so it will be ready when you configure Squeezebox Controller and Receiver for your network.

1.Select the correct plug adapter and slide it onto the AC adapter of the charging cradle. Make sure it snaps firmly into place.

2.Plug the AC adapter into an electrical outlet.

3.Insert the battery into the Controller:

Remove the battery cover on the back of the Controller. Use your thumbs to press down on the battery cover, and then slide it toward the bottom of the unit; it should move about 1/4 inch.

Insert the battery, making sure the This Side Up label faces up and reads correctly.

Place the battery end–marked with three arrows–into the battery slot first and slide it under the small plastic tab.

Replace the battery door, fitting the tabs on the door into the slots on the Controller.

Slide the battery door up toward the top of the Controller so it locks into place.

4.Place the Controller into the charging cradle. The Controller powers on and the battery pack begins charging. It may take up to four hours to charge the battery pack fully. However, you do not need a full charge to set up the Controller.

Page 8
Image 8
Logitech Duet manual Set Up the Hardware, Charge the Battery