Lopi Endeavor owner manual Outside Air Boot Installation Part number

Optional Equipment 37

Outside Air Boot Installation (Part number 99200134)

The outside air boot routes outside air to the stove for combustion. Refer to the section "Outside Air Requirements" for installation concerns. The directions below detail installation.

1Refer to the illustration below to determine the location and size of the hole penetrating the floor and hearth. The knock-out (which is pre-removed) is 6-3/8" behind the face of the stove - it is 8" wide and 4-1/4" deep. Cut the hole prior to locating the stove.

2Attach gasket to the bottom edge of the lower air boot section (near the screen). Attach gasket on top of the flanges on the upper air boot section. Slide the two sections together with both seams facing the rear (do not attach the two sections at this time).

3Follow the directions below for attaching the upper section of the air boot (with gasket) to the stove.

4Slide the lower section down until it contacts the hearth. Attach the two sections together following the directions below

Bottom of Stove

Attach the included gasket to all four top edges of the air boot.

5-1/8”

8-7/8”

Attach gasket to the bottom edge of the air boot.

Floor (and hearth)

Use a screwdriver to pry out the knock-out (if applicable).

Attach the air boot with
the two screws included
with the kit.
	1/4" Nutdriver
Use the included screws to attach
the two telescoping portions of air
boot together. The included drill bit
should be used to drill the hole.
Make sure the air boot is expanded
to the correct size before drilling.
9/64” Drill Bit	5/16" Nutdriver
The hole in the floor (and hearth)
must be a minimum 16 square
inches. It should be 1/2” smaller
than the footprint of the air boot in
each dimension to allow for the
gasket to seal.

© Travis Industries 100-01161 4040608