Lopi Revere Stove Installation for qualified installers only, Insert with Positive Connection

12 Stove Installation (for qualified installers only)

Insert with

Positive

Connection

NOTE:

Most factory-built chimney manufacturers make stainless steel chimney liners, either flexible or rigid. This provides a wide variety of installation options. Make sure to follow the manufacturer's instructions for installation and support

Install a non-combustible cover plate to prevent water from entering the chimney

NOTE: This installation may be used with a masonry or zero clearance fireplace. The requirements in the section "Masonry Fireplace Requirements" or "Zero Clearance Fireplaace Requirements" must be fulfilled prior to installation.

Combustible Mantle

Surround Panels

See the section "Insert

Placement Requirements" for

minimum clearances and

hearth required.

Cap (prevents water from entering)

Flue Liner

The liner must be stainless steel connector or flexible vent. Follow the liner manufacturer's insturctions for installation and

support.

Airtight Insulated Clean-Out

Remove damper or wire it open

		Figure 7
Insert with Direct	NOTE: This installation may be
	used with a masonry or zero
Connection	clearance fireplace. This
	illustration depicts a masonry
(Masonry	insert, all requirements in the	Flue
	section "Masonry Fireplace
Fireplace)	Requirements" must be fulfilled	Liner
	prior to installation.	Stainless steel
		chimney connector
NOTE:		must Extend 1' past
		the block-off plate or
		to the flue liner

Direct connections
require installation of	Combustible Mantle
an airtight block-off
		Airtight
plate or damper		Insulated
adapter (see "Block-off		Clean-Out
Plate Installation" on
page 11).		Remove
	Surround Panels	damper
		or wire it
		open
	See the section
	"Insert Placement
	Requirements" for	Block-off plate or
	minimum clearances
	and hearth required.	damper adapter
© Travis Industries	100-01165	4040806