Stove Installation (for qualified installers only) | 13 |
Insert with Direct Connection (Z.C. Fireplace)
NOTE:
Direct connections require installation of an airtight
NOTE: This installation may be used with a masonry or zero clearance fireplace. This illustration depicts a zero clearance insert, all requirements in the section "Zero Clearance Fireplace Requirements" must be fulfilled prior to installation.
Combustible Mantle
Surround Panels
See the section "Insert Placement Requirements" for minimum clearances and hearth required.
Stainless steel chimney connector must Extend 1' past the
Damper must be
Z.C. (Metal) firebox
Insert with Face Seal Connection
NOTE:
Face seal connections require installation of the surround panels and insulation (see the "Surround Panel Installation" on page 32)
Optional
Telescoping Legs
NOTE: This installation may be used with a masonry fireplace only. The requirements in the section "Masonry Fireplace Requirements" must be fulfilled prior to installation.
Flue
Liner
Combustible Mantle
Surround Panels with insulation (see "Surround Panels" installation instructions in the back of
the manual) |
See the section "Insert |
Placement Requirements" |
for minimum clearances |
and hearth required. |
No modification to the firebox of the z.c. fireplace is allowed.
NOTE: It is recommended your chimney have a minimum 28 and a maximum of 144 square inch cross- sectional area to use a face seal connection, otherwise your chimney maynot have sufficient draw for the fireplace insert to operate correctly.
Airtight Insulated
Remove damper or wire it open
© Travis Industries | 4040806 |