Setting Dwell Time
Setting Dwell Time
You can set the length of time (in seconds) that the receiver displays channels while in Auto Scan.
To set dwell time:
1.Make sure the Wireless Receiver and cameras are fully connected and powered on.
2.Press and hold the VGA/QVGA button and Pair button at the same until the Dwell Time screen appears. Continue holding both buttons.
3.With the Pair button and VGA/QVGA button held down, the receiver will automatically cycle the dwell time from 1~20 seconds. The higher the dwell time, the longer each channel remains on- screen during
4.Release both buttons to set the desired dwell time.
Note: If you repeat this process, the Dwell Time screen will display the last set dwell time.
Figure 7.0 Press and hold the VGA/QVGA and Pair buttons at the same time
Figure 7.1 Continue holding both buttons to set the dwell time for Auto Scan
15
