SIDE VALVE CONCEALER KIT - SVCK5/10
NOTE: This kit has been designed and certified for use with a Cozy gas baseboard heater only. Use only factory supplied kit and components.
STEP 1. With the offset up and out from the wall, place the mounting bracket flush to the right side of the heater cabinet. Align the top of the mounting plate with the top of heater cabinet. Mark the location of the mounting holes. See Figure 1.
STEP 2. Drill holes where marked. Depending on wall material, install wall anchors (nor provided) if needed.
STEP 3. Secure mounting plate to wall with screws (not provided).
STEP 4. Attach the cover to the mounting plate by placing the cover top edge over the offset on the mounting plate. Push the cover in toward wall until catch snaps into place. See Figure 2.
STEP 5. For access to the manual gas shut off valve, locate finger handle at the bottom of the cover. Pull out until snap catch releases then lift cover up to remove from mounting plate. See Figure 2.
Offset must be out
from wall
COZY Gas
Baseboard
HeaterMounting Holes (4)
Mounting
Plate
Manual gas shut
off valve
FIGURE 1
Cover
COZY Gas
Baseboard
HeaterCabinet
catch
Manual gas
shut off valve
Finger handle
FIGURE 2
Page 17