OPTIONAL KITS
For special installation applications and modifications, the following kits are available from your local dealer. To ensure safe, efficient operation of your Direct Vent Gas Baseboard be sure to use only authorized kits.
Table 1: Special adaptation and modification kits available for use with the Direct Vent Baseboard Heaters.
MODEL# | DESCRIPTION | CONTENTS |
VWSK5/10 | Vent Weather Seal Kit | 2” diameter PVC pipe, external wall seal, |
|
| PVC glue, instructions. |
|
|
|
VRK5/10 | Vent Riser Kit | Wall mount plate, |
|
|
|
SVCK5/10 | Side Valve Concealer Kit | 4” cabinet extension, wall plate, screws, instructions |
|
|
|
BVCK5/10 | Bottom Valve Concealer Kit | 4” cover, wall plate, screws, instructions |
|
|
|
|
|
|
| INSTALLATION |
WARNING: | Failure to follow these instructions carefully could result in poor performance, property damage, |
| personal injury, or loss of life. |
STEP 1. | LOCATE VENT OPENING (Requires a |
a) | Select area on wall where heater will be installed. |
b) | Check outside vent termination for proper clearances. See Figure 1. |
c) | Locate studs behind heater location. |
d) | Using template supplied, mark location for |
e) | Cut vent openings through both the inside and outside walls, being sure to maintain level |
| across both openings. |
|
|
| VENT HOLE LOCATION FOR THE AIR |
| INTAKE AND EXHAUST TUBES FOR |
| STANDARD INSTALLATION |
| HOLE. NOTE: 3” DIA. HOLE REQUIRED |
| FOR WEATHER SEAL KIT. |
| |
OF HEATER | |
| RIGHT END |
FLOOR |
|
Page 6 | FIGURE 2 |