VENT RISER KIT
VRK5/10
NOTE: This kit has been designed and certified for use with a Cozy gas baseboard heater only. Use only factory supplied kit and components.
WARNING: DO NOT INSTALL IN WINDOW WELL OR BELOW GRADE WHERE WATER MAY ACCUMULATE. MUST NOT TOUCH THE GROUND!
STEP 1. | Install Cozy gas baseboard heater per |
STEP 2. | installation instructions. |
Check that the air intake pipe extends | |
| |
| exhaust tube extends |
STEP 3. | wall. See Figure 1. |
Place the mounting plate over the air | |
| intake tube and slide back flush against |
| wall. Mark the location of the six |
STEP 4. | mounting holes on wall. See Figure 2. |
Drill the six mounting holes. Depending on | |
| wall material, install anchors (not |
STEP 5. | provided) if needed. |
Secure mounting plate to wall with screws | |
STEP 6. | (not provided). |
Place the vent riser kit over the vent | |
| exhaust tube, slide back into position and |
| secure to mounting plate with screws |
| provided. See Figure 3. |
WALL
AIR INTAKE
TUBE
VENT
EXHAUST
TUBE
FIGURE 1
MOUNTING
PLATE
AIR | MOUNTING | |
HOLES | ||
INTAKE | ||
| ||
TUBE |
| |
| VENT EXHAUST | |
| TUBE |
FIGURE 2
VENT RISER KIT
INSTALLED
FIGURE 3
Page 16