| SCAN | Scan (ALL SCAN & 3CH SCAN) | |
| There are two SCAN modes you can use to find the broadcast channel: | |
| • | ALL SCAN mode scans ALL channels in sequence, and checks the priority |
| channel every 2 seconds. | |
| • | 3CH SCAN mode scans the favorite channels and CH16. |
| When a signal is received, scanning stops at that channel and BUSY appears on the | |
| LCD. If the signal ceases for more than 5 seconds, the scan restarts. | |
| Press SCAN or PTT to stop at the current channel. | |
| If you are in NAVIGATION mode and want to scan the DSC channels while staying in | |
| that mode, just hold down SCAN. | |
| Note: SCAN functionality is limited in some European countries and, if ATIS mode is | |
| enabled, the 3CH SCAN mode will be disabled and an error beep will sound. | |
| Note: The weather channel is also scanned if TONE ALERT or SAME is ON (US only). | |
| ALL SCAN mode: | |
| Hold down SCAN for about 3 seconds to start an ALL SCAN. ALL SCAN appears on the | |
| LCD. |
|
| Press ENT to temporarily skip over (lock out) an “always busy” channel when in ALL | |
| SCAN mode. SKIP is shown on the top line of the LCD to designate a skipped | |
| channel. SKIP will disappear when the radio is powered OFF/ON. With scanning OFF | |
| and the SKIP channel selected, press ENT to cancel the skipped channel. | |
| Note: It is not possible to skip over the priority channel. | |
| Press SCAN to stop at the current channel. | |
| Press EXIT to cancel scan mode and return to normal operation. | |
| 3CH SCAN mode | |
| With any of your three favorite channels selected (by pressing the 3CH key) hold down | |
| SCAN to start all 3CH scanning. Press SCAN again to stop at the broadcast channel, | |
| or press EXIT to quit 3CH SCAN and return automatically to the previous broadcast | |
| channel. | |
| AIS / IC | AIS (Automatic Identification System) | |
| Quick press to enter the AIS menu. | |
| See section 6 for AIS setup or Section 9 for AIS functionality. | |
14 | Lowrance - |