Lucent Technologies 8410, 8403, 8411, 8434DX Line jack Adjunct jack Expansion Handset Module jack

Models: 8410 8434DX 8411 8403 8405

1 31
Download 31 pages 1.6 Kb
Page 13
Image 13

Routing channel

!

USE ONLY WITH

 

 

COMMUNICATION

 

 

SOURCECIRCUIT POWER

 

 

Lucent Technologies

 

EX MOD

MADE IN U.S.A.

 

 

 

U

LISTED

HAC

 

Telephone

 

L

91B0

 

 

Equipment

 

> ABS<

Line jack

Adjunct jack

Expansion

Handset

module jack

jack

NOTE: The location of the jacks and the routing channel

on the back of your voice terminal may differ slightly from the location shown in this figure.

FIGURE 4: Line, Adjunct, Handset, and Expansion Module Cord Routing on the 8434DX Voice Terminal

7.Turn the voice terminal right side up, with the front facing you.

8.Snap the free end of the handset cord into the handset and place the handset in the cradle.

9.Snap the free end of the line cord into the modular wall jack.

Refer to the section, “Attaching Adjunct Equipment” for information about connecting an 8400-Series voice terminal to the wall jack when an adjunct is used.

10.Lift the handset and listen for dial tone. If there is no dial tone, check all wire

connections to make sure they are secure. Also, perform a self-test to see if the

terminal is receiving power. (Press and hold down the Test button. If the light next to the button flashes rather than goes on steadily, it means the terminal is not able to communicate with the switch. If the Test light does not go

6

Page 13
Image 13
Lucent Technologies 8410, 8403, 8411, 8434DX, 8405 user manual Line jack Adjunct jack Expansion Handset Module jack