•
•
1145B1 Bulk Power Supply (PEC:
Battery for the 1145B1 (2 amp battery = PEC: 24700;
or 5 amp battery = PEC: 24701)
NOTES: The
It is recommended that the 1145A and the 1145B Bulk Power Supplies be used as auxiliary power for the 8434DX voice terminal. These power supplies provide battery
If an 8434DX voice terminal with attached adjunct equipment is connected to an expansion module, it should be locally powered by an
General Notes for Installation
Regardless of which configuration is in use, ALL wiring between the PBX and the terminal MUST consist of
An
You do NOT need to change any settings on the voice terminal for
Desktop Installation
The following instructions are for a desktop installation. If you are mounting the voice terminal on the wall, proceed to the next section, “Wall Installation.”
NOTE: During the desktop installation procedure, refer to Figures 1, 2, 3, and 4 for the location of the jacks referred to in the following steps.
•Figure 1 shows the back of one of the 8403 voice terminal models. (Use this figure for installing the 8403, 8405, and 8410. However, note that the location of the jacks on the back of your voice terminal may differ slightly.)
•Figure 2 shows the back of the 8411 voice terminal, and Figure 3 shows the
two jacks on the rear of the 8411. Use the RS-232-D jack for connecting a PC dedicated to PassageWay® Solution software and the Analog Adjunct
2