![](/images/new-backgrounds/1117982/11798253x1.webp)
To select which channel (the
1. | While | Shift | |||||
|
| The light next to |
|
|
| ||
| • |
| Shift | ||||
2. | Press |
| . |
|
| ||
Mute |
|
| |||||
|
| The light next to |
|
|
| ||
| • |
| Shift |
.
goes on.
goes off.
3.Enter the
•
•
The red light next to Shift flutters.
The current setting (either T/R ON I1 CHANNEL or T/R ON I2 CHANNEL) is shown on the display, if there is one.
4.Press either “1” or “2” to change the setting:
•
•
•
Press “1” to select the
Press “2” to select the
or if the voice terminal has a display, press * to change the setting. Press
#to save the desired option and then exit programming.
After pressing “1” or “2” or pressing # , the light next to Shift goes off and one of the following voice terminal responses occurs:
If the voice terminal saves your selection, the first three green call appearance lights go on and, if you have a display, a confirmation message is displayed.
If the voice terminal cannot save this selection, the first three red call appearance lights go on and, if you have a display, an error message is displayed. In this case, the selected option will be in effect until power is removed from the set. If this happens, try repeating the process. If the option still cannot be saved, the terminal may be faulty.
Enabling/Disabling the Status Lights for the Analog (Tip/Ring) Adjunct Interface (For the 8411 Only)
If an Analog Adjunct has been connected to the Analog Adjunct jack on the rear of the 8411 voice terminal, the user can use the lights next to Button #10 (the last button in the second column) to see the status of the Analog Adjunct connection. These indications show:
•Status of the ringing signal being sent from the voice terminal to the Analog Adjunct) (on OR off)
•
•
Switchhook status of the Analog Adjunct
Status of the
20