4.Place the voice terminal face down on a flat surface and turn the terminal face down.
5.Remove the desktop stand which is attached to the base of the voice terminal by tabs on the top and back of the stand. See Figure 7.
—Press inward on the top of the stand until you can lift the top of the stand out of the tab slot on the voice terminal.
—Lift the bottom of the stand out of the lower tab slot(s).
FIGURE 7: Removing the Desktop Stand on the 8403, 8405, and 8410
6.Snap the
7.Pass the
8.Snap one end of the coiled cord into the Handset jack (labeled ), as shown in Figure 8. (On some 8403 voice terminal models, you may need to thread the cord into the channel leading to the side edge of the voice terminal; the handset cord will then lead off the side of the voice terminal.)
WARNING: Do not insert the handset cord into the Adjunct jack. It may cause equipment damage.
9.Snap the free end of the
10.Place the base of the voice terminal on the
10