Lucent Technologies 8410, 8403, 8411, 8434DX, 8405 Current setting Enable T/R Status Lamps or

For a more detailed list of Analog Adjunct (Tip/Ring) status light indications, see “PassageWay and Analog Adjunct Status Indications on the 8411” earlier in this manual.

To enable or disable the status lights for the Analog Adjunct interface

1.	While on-hook, press				Shift	.
		The light next to				goes on.
	•				Shift
2.	Press			.
			Mute
		The light next to				goes off.
	•				Shift

3.Enter the 2-digit code, “25” (“AL”).

•The red and green lights next to Button #10 flutter.

•The current setting (ENABLE T/R STATUS LAMPS or

DISABLE T/R STATUS LAMPS) is shown on the display, if there is one.

4.Press either “1” or “2” to change the setting:

•

•

Press “1” to enable the status lights for the Analog (Tip/Ring) Adjunct connected to the Analog Adjunct jack

Press “2” to disable status lights for Analog Adjunct connection (so the button is thus used in the normal way, that is, for call appearance or feature indications)

or if the voice terminal has a display, press * to change the setting. Press

#to save the desired option and then exit programming.

• After pressing “1” or “2” or pressing # , the light next to Shift goes off and one of the following voice terminal responses occurs:

If the voice terminal saves your selection, the first three green call appearance lights go on and, if you have a display, a confirmation message is displayed.

If the voice terminal cannot save this selection, the first three red call appearance lights go on and, if you have a display, an error message is displayed. In this case, the selected option will be in effect until power is removed from the set. If this happens, try repeating the process. If the option still cannot be saved, the terminal may be faulty.

21