M&S Systems WG100W, WG150C, WG150W owner manual you do not cut the hole larger than the outline

you do not cut the hole larger than the outline.

Step 7. Be sure to clear any insulation material from the speaker back.

Step 8. After you have determined the speaker locations secure a 16 gauge 2 conductor cable to the stud using an insulated staple. Leave at least 18 inches of additional cable for connection during final speaker installation. Run the other end of the speaker cable to the audio source.

Step 9. Prepare the speaker wiring by stripping off approximately 3 inches of the outer jacket (care should be taken so the insulation on the wires inside the jacket are not damaged) also strip approximately 3/8 inch off the ends of the two inside conductors. Twist the ends of the stranded cable so the wires are tight.

Step 10. Follow the instructions included with the volume control and amplifier.

Step 11. You are now ready to install the frame. Remove the paint mask. Be careful not to touch the speaker cones and tweeters when removing the paint mask in order to prevent any damage. Remove the baffle from the frame and fasten the frame to the drywall. Index the mounting tabs to make sure that all tabs will clear the opening. Insert the frame in the wall and tighten the tabs with the screws on the front of the baffle. Attach the speaker cable to the speaker by pressing down on the red (+) or black (-) gold-plated push terminals and inserting the red wire in the red terminal and the black wire in the black terminal. See figure 10. Make sure that

Page 21