M&S Systems WG150C, WG100W, WG150W owner manual Not Press On The Cone Directly

none of the strands from the black and red wires are touching each other. This can create a short circuit that can damage your electronics. Mount the baffle to the frame using the 6 screws provided. Do not over tighten the mounting screws.

Step 12. After the speaker is mounted, adjustments to the swivel tweeter (small speaker) can be made by either directing the sound visually or by using a musical source to determine the best sound coverage for the listening area. To position the tweeter, press at the outside edge of the tweeter housing (DO

NOT PRESS ON THE CONE DIRECTLY).

Note the crease in the asymmetrical tweeter provides the highest directional response in this direction. See figure 11 on page 14.

If you require to disperse the sound in a 180- degree pattern you must position the line in the tweeter in a horizontal position. See figure 12 on page 15.

The combination of switch settings allow you to boost and cut bass and treble +/-3dB. Adjust the speaker level to accommodate for room acoustics. See figure 13 on page 15.

Step 13. Divide each adhesive bead strip in half. (Adhesive bead strips are in the clear self-closing bag). Place strips on the edge of the grille as shown in figure 14 on page 15. Reinstall the grille on the speaker.

Step 14. Adhere the WG Series logo to the grille with the pressure sensitive tape.

Page 22