•Do not install the actual speaker until the wall
board is in place. Until then leave several feet of wire secured to the back of the mounting ring. The excess wire can be removed during final installation.
During the drywall installation, make sure the speaker
Step 2. After you have determined the speaker locations using the guidelines above, secure a 16 gauge 2 conductor cable to the mounting ring
| tabs | (see figure | |||
| 9), such | as | the | ||
| M&S | Systems | |||
| MS16X, | for | at- | ||
| tachment | to | the | ||
| speakers after the | ||||
| dry wall has been | ||||
| installed. Leave at | ||||
| least | 18 | inches | ||
| additional | cable | |||
| for the connection | ||||
| d u r i n g | f i n a l | |||
| speaker | installa- | |||
| tion. | Run | the | ||
| other | end | of | the | |
FIGURE 9 | speaker cable | to | |||
the audio source. | |||||
|
NOTE: Make a drawing of each speaker location. This will assist you in locating the wires that have been covered after the sheet rock has been installed.
Page 12