M&S Systems WG150W, WG100W, WG150C owner manual Positive red Negative black

Models: WG150W WG150C WG100W

1 24
Download 24 pages 36.48 Kb
Page 8
Image 8
Positive (red)

installed. Leave at least 18 inches additional ca- ble for the connection during final speaker instal- lation. Run the other end of the speaker cable to the audio source.

NOTE: Make a drawing of each speaker location. This will assist you in locating the wires if they have been covered after the wall board has been installed.

Step 3. This is the finish-out stage. Prepare the speaker wiring by stripping off approximately 3 inches of the outer jacket (care should be taken so the insulation on the wires inside the jacket are not damaged) also strip approximately 3/8 inch off the ends of the two inside conductors. Twist the ends of the stranded cable so the wires are tight.

Step 4. Follow the instructions included with the volume control and amplifier.

Step 5. You are now ready to install the speaker. Remove the paint mask from the baffle. Be careful not to touch the speaker cones and

FIGURE 3

Positive (red)

Negative (black)

Page 8

Page 8
Image 8
M&S Systems WG150W, WG100W, WG150C owner manual Positive red Negative black