Mabe Canada JCBS640, JCBS630 Before you call for service…, Problem, Possible Causes, What To Do

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

Before you call for service…

Troubleshooting Tips

Problem	Possible Causes	What To Do
Oven temperature too	Oven thermostat	!See the Adjust the oven !"#$%&'!(!)*('+ to do
hot or too cold	needs adjustment.	+&,rself! section.
Clock and timer do	Plug on range is not completely	! Make sure electrical plug is plugged into a live, properly
not work	inserted in the electrical outlet.	grounded outlet.
	A fuse in your home may be	! Replace fuse or reset circuit breaker.
	blown or the circuit breaker
	tripped.
	Oven controls improperly set.	!See the Using the clock, timer and convenience outlet
		section.
Display goes blank	A fuse in your home may be	! Replace the fuse or reset the circuit breaker.
	blown or the circuit breaker
	tripped.
	The clock is turned off from	! See the Using the clock, timer and convenience outlet
	showing in the display.	section.
Oven door is crooked	The door is out of position.	! Because the oven door is removable, it sometimes
		gets out of position during installation. To straighten
		the door, push down on the high corner.
Oven makes	This is the sound of the	!This is normal.
clicking noise	heating element turning
	off and on during
	cooking functions.
“F and a number	You have a function error code.	! Press the OFF pad. Put the oven back into
or letter” flash in		operation.
the display
	If the function code repeats:	! Disconnect all power to the range for at least 30
		seconds and then reconnect power. If the function
		error code repeats, call for service.
		! On self-cleaning models, if a function error code
		appears during the self-cleaning cycle, check the oven
		door latch. The latch may have been moved, if only
		slightly, from the locked position. Make sure the latch
		is moved to the right as far as it will go. Press the
		OFF pad. Allow the oven to cool for one hour. Put
		the oven back into operation.
Power outage	Power outage or surge.	!Some models will automatically resume their setting once
clock flashes		the power is restored. On models with a clock, you must
		reset the clock. If the oven was in use, you must reset it by
		pressing the OFF pad, setting the clock and resetting any
		cooking function.
Display flashes	Power failure.	!Reset the clock.
Unable to get the display	Oven control pads were not	!The BAKEand BROIL pads must be pressed
to show “SF”	pressed properly.	at the same time and held for 3 seconds.

34