|
|
Network | IP is set by using or input the exact numbers to change | |
the IP address. IP address setting can only be here. The related | ||
| ||
SUBNETMASK and GATEWAY should be set according to the IP | ||
address. MONITOR and PLAYBACK can be changed by using | ||
TCP/IP or MULTICAST. Save the setting in SAVE, and restart the | ||
recorder.
Note:
MULTICAST: The users with Admin levels can monitor each channel freely. All other users can only view after Admin releases camera. 5 users at maximum.
TCP Protocol: All users are able to monitor any channel. User shall select Camera # desired. If the transmission is over Internet, TCP should be chosen. 2 users can log in at a maximum.
Motion detection | Select the Camera channel in | CH | . Open or close (On/Off) | ||
| the function in |
| . Choose how long you want to | ||
| STATE | ||||
continue the recording (10, 20, 30, ……90SEC) when motion is detected
and then cleared. ALMOUT controls the alarming state for motion detection. SENS has three levels: LOW, MID, HIGH. AREA can be
accessed by pressing ENTER. The setting area can be divided in 192 sections. Red section means the current cursor position, and the blue section is the motion detection area. Areas with no color are no motion detection areas. Press Fn to locate the current section, then move the cursor to cover the MD area needed; press Fn again to choose the MD area. Press to get the setting and press ENTER to confirm.
CH | 1 |
DELAY | 30 SEC |
ALMOUT | OFF |
SENS | MID |
AREA | SET |
SLOT1 | 08:00AM – |
SLOT2 | 08:00AM – |
SAVE CAMCE;
35 | ! |
