17
· Connect the alarm input according to the device connection and the instructions.
· Connect the related alarm output relay on the DVR to associated alarm device. Example: lights, beeper, etc.
· Program the associated information in the menu. See details at Menu>System setting>Alarm setting
4. Pan-tilt control operation
· Confirm the proper connection of the pan-tilt-zoom and Communication Protocol. Set the Camera address.
· Confirm the proper wiring connection between the PTZ and RS -485 A & B lines and DVR’s 25-pin port’s A
& B lines.
· Set up the programming. See details at Menu>System setting>Control
· Select full screen call-up of associated P/T/Z Camera.
· Press and hold “Assistant” on the remote controller or “Fn1” on the front panel to select
· Use direction arrow keys to move and control the selections on the screen
5. Network connection operation · Confirm correct network connections between DVR and computer
· Set the IP address, subnet mask and gateway of the computer and DVR separatel y. If there is no router in the
network, only t he IP address is needed. If there are routers in the network, please enter the related gateway
and subnet mask.
· Ping ***.***.***.*** t he IP address of the DVR to check the link of the network. A successful re ply shall
look like (TTL value less than 64 ms is normal):
Reply from 68.153.205.130: bytes=32 time=31ms TTL=57
· Open IE browser and input the IP address of the DVR you want to log in to.
· For Network operation see details at Chapter 4