|
|
Image | In | CH | option select the related channel. In MODE there are CBR |
|
(audio/video) and VBR (audio/video). AV is audio and video synchronization, Video is the mode without audio (when there is no audio input
use this way to save HDD space).When in CBR, Framerate is Real time, Bitrate is the related maximum data flux. Use direction key to select the different bitrates. When in VBR, Framerate
Alarm |
| Select the relevant Camera in | CH | (this recorder has | ||||
|
|
|
|
|
|
|
| |
| TYPE | has NO (normal open) NC (normal close) output modes. If the | ||||||
|
| |||||||
| Camera number in RECORD is selected, recording would be started for that | |||||||
| Camera automatically when there is alarm input. If the alarm output port is | |||||||
| chosen, it will trigger the corresponding relay when there is an alarm input. | |||||||
|
| means to extend the recording time after receiving alarm signal | ||||||
| DELAY | |||||||
| clears.10, 20, 30 90SEC delays. When the outside alarm is cleared, the | |||||||
| system will extend the recording time automatically before closing alarm and | |||||||
| relay output. When Time 1 or Time 2 are on, if an alarm occurs within the time | |||||||
| of these settings, the recording will be triggered by alarm signals. The beginning | |||||||
| time should be earlier than the ending time. The setting in Time 2 should be | |||||||
| later than the setting in Time 1. |
| is used to transmit the alarm signals | |||||
| ALMSVR IP | |||||||
| to the designated IP server. | |||||||
Select the corresponding channel in CH, and choose the protocol of the brand name of the corresponding
PROTOCOL. ADDR is the address of the corresponding PTZ Camera.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| CH | 1 |
|
| |
|
| MODE |
| CBR AV | ||
|
| FRAMERATE | REAL | |||
|
| BITRATE | 1024K | |||
|
| VIDEO LOSS | OFF | |||
|
| COVERED | OFF | |||
|
| VIDEO | SET DEFAULT | |||
|
| TITLE | 01 | ON | ||
|
| CYCLE |
|
| OFF | |
|
|
| SAVE | CANCEL | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
34 | ! |
