Magenta setup guide Appendix B. XR2000 Configuration Settings

MAGENTA MULTIVIEW™ SERIES

Appendix B. XR2000 Configuration Settings

Note: XR2000 receivers are typically pre-configured at time of order and will have factory configuration indicated on the bottom of the unit.

The factory configuration may be changed or checked by using the following jumper location diagram as well as Table B-1 for jumper settings.

Figure B-1. XR2000 Jumper locations.

JP13 controls sync clamping circuitry and has 3 settings depending on the video signal in use:

RGBHV computer video with separate horizontal and vertical sync == JP13 1-2 Non RGBHV computer video, component RGB/YUV, S-video, composite video or RGsB video == JP13 2-3

Auto sense video mode == JP13 non-jumpered.

146