CABLE BOX CONNECTION
If your cable signal uses a cable box or decoder, follow the steps below to complete the connection.
Cable Box (w/RF In/Outputs) :
Cable Box (w/RF In/Outputs):
1Connect the Cable Company supplied cable to the signal IN(put) plug at the back of the Cable Box.
2Using a separate round coaxial cable, connect one end of the OUT(put) to TV plug on the back of the Cable Box.
3Connect the other end of the round coaxial cable to the 75Ω input on the back of the television. Screw it down finger tight.
NOTE : If applicable , set the OUTPUT CHANNEL SWITCH on the back of the cab le box to CH3 or 4. Tune the TV to the same channel and change channels at the cable box. In some cases, the cable box will automatically tune to either channel 3 or 4, change channels until the picture appears.
Cable Signal IN from the
Cable Company
2 
1
|
|
|
| AUDIO IN | SPDIF |
| VIDEO |
|
|
|
| IN | OUT | ||
| CABLE |
| R | L |
|
| |
TO | IR |
|
|
| |||
IN |
|
|
|
| |||
TV/VCR |
|
|
|
|
|
| |
|
|
|
|
|
|
| |
|
|
|
| AUDIO OUT | Y | Pb | Pr |
|
| USB | TV |
|
|
| OPTICAL |
|
|
| PASSCARD |
|
|
| SPDIF |
Jack Panel Back of Cable Box
3
75 
Round 75Ω | Jack Panel Back of TV | |
Coaxial Cable | ||
|
HELPFUL HINTS
If no Video Signal is present, the TV will shut itself off in about 10 minutes. If the TV is tuned to the AV channel and there are no Video Signal present, the screen will remain black and the TV will shut itself off in about 10 minutes.
6
