14
EN
PREPARATION
Initial Setup
This section will guide you through the unit’s initial setting which includes
selecting a language for your on-screen menu and autoprogram, which
automatically scans and memorizes viewable channels.
Before you begin:
Make sure the unit is connected to antenna or cables.
1After making all the necessary connections,
press [
y
y (power)] to turn on the unit.
This operation may take a few moments.
2Use [Cursor K / L] to select the on-screen language
from the choices on the right side of the TV screen.
(English / Español / Français)
t
Initial Setup
Select the language for setup display.
Elja el idioma de ajuste.
Sélectionner langue écran config.
Español
Français
Seect Skip
MENU
OK
OK
Englsh
“Initial Setup” menu on step 3 will be displayed in the
selected language after you press [OK].
3Use [Cursor K / L] to select “Antenna” for TV channels
or “Cable” for CATV channels, then press [OK].
Initial Setup
Initial Setup
Seect Skp
MEBK
BackOK
OK
Make sure the antenna is connected to ''ANT. IN' jack.
Select your signal source.
Cabe
Skip
Antenna
Cabe
Antenna
Or ANTIN
“Autoprogram” will begin.
t
Initial Setup
Now the system is scanning for channels, please wait.
Auto programming wil take up to 20 minutes to complete.
Skp
MENU
0%
Analog channels 0ch
Digtal channels 0ch
5
•
•
•
4Use [Cursor
s
/
B
] to select the desired location setting,
then press [OK].
S
Initial Setup
Select “Retail” or “Home” for your location.
OK
OK
Retail Home
Select
Select ”Retail”, the unit will be set up with predefined
setting for retail displays.
Select ”Home”, the unit is set to maximize the energy
efficiency for home setting and it can be adjusted
through a choice of picture and sound quality
according to your preference.
When the initial setup is completed, the lowest
memorized channel with the confirmation message
of the location setting will be displayed on the TV
screen.
Note:
• If you connect the cable system directly, contact the CATV
installer.
• If you press [
y
y
(power)] or [MENU] during autoprogram,
this setting will be canceled.
• The initial autoprogram function can be executed for
either “Antenna” or “Cable” only once. When you change
the connection (Antenna / Cable), set autoprogram again.
(Refer to page 19.)
• If there is no signal input from the antenna terminal and
no operation for several seconds after you turn on the unit,
“Helpful Hints” appears. Follow the instructions listed on
the TV screen.
t
Initial Setup
Select Skip
MENU
No channel is registered.
Try Autoprogram again?
Verfy that you have a cable connected to the "ANT. IN" jack on the
back panel of the TV, he cannel installaion process searches this
connection. f you are using a cable or satelte box please conirm
the input to which you have connected the box and use "SOURCE"
key on the remote control to tune to he appropriate source input.
Laer
Retry
OK
OK
• You must set ”Home” in step 4. Otherwise, the settings
of picture and sound quality you adjusted will not be
memorized after you turn off the unit.
After an initial setup is completed...
If you want to scan the channels automatically again,
refer to “Autoprogram” on page 19.
You can add the desired channels unmemorized by
“Autoprogram”. Refer to “Add Channels” on page 20.
If you want to change to another language, refer to
“Language Selection” on page 21.
If you want to change the location setting, refer to
“Location” on page 32.
•
•
•
•
•
•
•