Magnavox MDV560VR/17 warranty Getting Started, Connections, Connecting Antenna/Cable TV to

Connections

Tips

∀Depending on your TV and other equipment, there are various ways you could connect the DVD+VCR. Use connections described on pages 11-13.

∀Please refer to the manuals of your TV, VCR, Stereo System or other devices as necessary to make the best connections.

∀For better sound reproduction, connect the DVD+VCR’s DVD/VCR AUDIO OUT jack to the audio in jacks of your ampli- fier, receiver, stereo or audio/video equipment. See “Optional, Preferred TV Connections” on pages 12-13.

Caution

∀Make sure the DVD+VCR is connected directly to the TV. Tune the TV to the correct video input channel.

∀Do not connect the DVD+VCR’s DVD/VCR AUDIO OUT jack to the phono in jack (record deck) of your audio

system.

∀Do not connect your DVD+VCR via your VCR. The DVD image could be distorted by the copy protection system.

Connecting Antenna/Cable TV to

DVD+VCR

1 Disconnect the antenna leads from the rear of the TV.

2 Identify the type of cable from your antenna. If it is a round cable as illustrated, it is a 75 ohm coaxial antenna cable. This cable will connect directly to the jack marked ANT.IN on your DVD+VCR.

Tip

If your antenna lead wire is a flat type antenna cable, connect it to a Antenna Adaptor (300-ohm to 75-ohm) (not supplied) and slip the Adaptor onto the ANT.IN jack. The Adaptor does not screw on to the DVD+VCR, it just slips over the jack.

Getting Started 11

Without Cable Box

If your cable wire is connected to your TV without a converter or descrambler box, unscrew the wire from your TV and attach it to the ANT.IN jack on the DVD+VCR. Use the supplied round coaxial cable to connect between the DVD+VCR’s RF.OUT jack and the 75 ohm antenna input jack on the TV. With this connection, you can receive all midband, super band, and hyperband channels.

With Cable Box

If a converter is required in your cable system, follow the instruc- tion below:

The cable hookup permits both TV and DVD+VCR operation.

To view or record CATV channel

1Tune the TV to the DVD+VCR output channel (CH 3 or 4).

2Set the DVD+VCR channel selector to the output channel of the Cable Converter box by using the CHANNEL (v/V)or number (0-9) of your DVD+VCR. (Example: CH3)

3Select the channel to view at the Cable Converter Box.

Notes

∀With this connection, you CANNOT record one program while viewing another.

∀If you are using a cable box to tune channels, it is not necessary to do Auto Channel Set as indicated on page 15.

English