Magnavox MRD120 warranty Setting the TV, Using the remote control to operate the system, panel

Step 1: Inserting batteries into the remote control

1Open the battery compartment.

2Insert two batteries type R06 or AA, following the indications (+-) inside the compartment.

3Close the cover.

Using the remote control to operate the system

1 Aim the remote control

directly at the remote	PLAY/PAUSE STOP PROG
	PREV	VOLU
		NEXT SOURCE
sensor (iR) on the front
panel.

2Select the source you

wish to control by pressing one of the source select buttons on the remote control (for example TV/AV,TUNER.)

3 Then select the desired

function (for example ÉÅ, S, T).

CAUTION!

–Remove batteries if they are exhausted or if the remote is not to be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

16

Step 2: Setting the TV

IMPORTANT!

Make sure you have completed all the necessary connections. (See pages 10–11 “Connecting TV”.)

1Press SOURCE control until “DISC” appears on the display panel (or press DISC on the remote.)

2Turn on the TV and set to the correct video-in channel. You should see the blue DVD background screen on the TV.

➜Usually this channel is between the lowest and highest channels and may be called FRONT,A/V IN, or VIDEO. See your TV manual for more details.

➜Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.

➜Or, the TV remote control may have a button or switch that chooses different video modes.

➜Or, set the TV to channel 3 or 4 if you are using an RF modulator.

001-037-MRD120-37-Eng	16	8239 300 30533
		18/03/2004, 02:19 PM