mvr630mg.QX33 2/11/02 12:05 PM Page 11
| Turning on Your VCR 11 |
Before turning on your VCR, make sure batteries are in the | 2 Turn on the TV. |
remote control and you have connected the VCR and TV | |
correctly. Details are on pages |
●You can not program channels if you are using a Cable Box or a Direct Broadcast System.
1
2
Press the POWER button. The VCR/TV light and the POWER light will appear on the VCR display panel.
Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The display shown below will appear on the TV screen. (If the display does not appear, check your hookups, then follow the steps on page 12 to set up channels and page 17 to select a lan- guage.)
1
4
POWER VCR/TV EJECT
|
| PLAY |
|
|
REW |
|
|
| F.FWD |
|
| STOP |
|
|
MENU |
| STATUS/EXIT |
| CLEAR |
|
|
|
| |
1 | 2 |
| 3 |
|
4 | 5 |
| 6 | CH |
|
|
7 8 9
3
5
SELECT op
0
→ ENGLISH | ON |
ESPAÑOL |
|
SPEED TIME SEARCH STILL/PAUSE
REC/OTR MEMORY SLOW
MAKE SELECTION OR
PUSH MENU TO CONTINUE
3 Within 60 seconds, press the PLAY/o button or the STOP/p button to select English or Spanish on- screen displays and menus.
4 Press the MENU button. The display shown below will appear.
CONNECT ANTENNA OR CABLE
TO VCR
THEN . . .
PUSH CH UP KEY
OR . . .
FOR PLAY ONLY – PUSH STOP
5 Within 60 seconds, press the CH(annel) o button to begin automatic channel programming. AUTO CH PROGRAMMING IN PROCESS PLEASE WAIT will appear on the TV screen. The VCR will memorize all available channels. When all channels are memorized, CHANNELS ARE SET will appear on the TV screen briefly, then TV programming will appear.
Now, when you press the CH(annel) o/p button, you’ll only scan through channels that you receive. You can still select other channel numbers using the Number buttons.
Helpful Hints
•To skip this feature and play a tape immediately, insert a tape with its record tab removed. Or, to skip step 3, press the MENU button. All on- screen displays will be in English. To skip step 5, press the STOP/p but- ton. Channels will not be pro- grammed, and CHANNELS NOT SET will appear on the screen.
•If you try to program channels when there is no antenna or cable connected to the VCR, programming will appear to take place, but even- tually a NO TV SIGNALS message will appear. Connect an antenna or cable to the VCR’s ANT(enna) IN Jack and press the CH(annel) o button again. You may need to fol- low the steps on page 12.
•You may need to repeat the steps on this page if a power failure occurs.
•If you used the AUDIO and VIDEO OUT jacks to connect the VCR to the TV, see page 10. You need to choose a channel other than 3 or 4 at the TV to see the VCR image on your TV.
