Majestic Appliances 39LDVR Operating Instructions, Glass Information, Louvre Removal, 10007317

LDVR Series Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Specialty Home Products should be used on this fireplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket) is available through your CFM Specialty Home Products dealer and should only be installed by a licensed qualified service person.

Louvre Removal

	Lower Clamps
		Window
		Frame
Window		Assembly
Frame		Pull Clamp
Assembly
	Push	Hook
	Clamp

The top louvre panel is removed by lifting the panel vertically and pulling it away from the appliance. (Fig. 39) The lower access door is hinged along the bottom edge and is folded down to allow access.

2.

Louvre

1.

Glass Panel

FP1227

Fig. 39 Remove top louvre assembly.

Handle FP1228

Fig. 40 Window frame assembly removal.

Glass Cleaning

It is necessary to periodically clean glass. During start- up condensation, which is normal, forms on the inside of the glass. This condensation causes lint, dust and other airborne particles to cling to glass surface.

Also initial paint curing may deposit a slight film on the glass. It is therefore recommended the glass be cleaned two or three times with a non-ammonia based household cleaner and warm water (We recommend gas fireplace glass cleaner) within the first few weeks of

Window Frame Assembly Removal

1.Turn the fireplace OFF (including the pilot)

2.If the unit has been operating allow time for the components to cool.

3.Remove the top louvre assembly.

4.Open the lower louvre panel.

5.Release the two clamps securing the lower edge of the window frame assembly by pulling down on the handles. (Fig. 40)

6.Tilt the window frame assembly out slightly at the bottom, lift the window frame assembly up and away from the fireplace.

7.To replace the window frame assembly reverse the procedure.

operation.

After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Clean glass after first two weeks of operation.

Do not clean glass when hot. Do not use abrasive cleaners. Do not strike or slam the glass.

22 10007317