Makita BPT351 specifications Boss a, See Fig. D-6, See Fig. D-7

Wiring diagram

Fig. D-5

P 15/ 15

Lead wire (red) to + Terminal of DC motor

Boss A	Switch put under ON-OFF Switch
	(for Upper dead point detection)
	Switch (for ON-OFF)

Guide Lead wire (red) of Upper dead point detection switch to DC motor while passing the wire between boss A and lead wire holder A.

Fix lead wire (black) of ON-OFF switch with lead wire holder A.

Lead wire holder A

Lead wire (black) for connecting ON-OFF switch and Upper dead point detection switch

Pass the following lead wires between rib and inner wall of Housing L.

*Lead wire (orange) for connecting ON-OFF switch with terminal *Lead wire (orange) for connecting Switch for LED circuit with Terminal *Lead wire (red) for connecting

LED circuit with Switch for LED circuit *Lead wire (red) for connecting

Start point regulator and DC motor

See Fig. D-6.

Terminal

See Fig. D-7.

LED circuit

Lead wire	Switch (for ON-OFF) put on
holder A	Upper dead point detection switch

See Fig. D-5.

Light switch arm

Switch for LED circuit

Rib

Lead wire holder B

DC motor

Fig. D-6

Fig. D-7

Lead wire holder B

Lead wire (red) of Upper dead point detection switch

LED lead wire (red) [It is thinner than Lead wire (red) of Upper dead point detection switch.]

Wall of Housing L

to Terminal	to Switch for
	LED circuit
	Rib B
	Rib A
	LED circuit

Pile lead wire (red) of Upper dead point detection switch on LED lead wire (red), and then pass these lead wires between lead wire holder B and the wall of Housing L.

Lead wires (red and black) of LED circuit pass between Rib A and Rib B so as not to put them on the LED circuit.