Makita DCS34 manual Technical data DCS, Approved bar and chain combinations, Length

Technical data	DCS 34
Single-cylinder two-stroke
Piston displacement	2.0 cu. in (33 cm3)
Cylinder bore	1.45" (37 mm)
Piston stroke	1.22" (31 mm)
Max. power at speed	1.3/9,000 kW/rpm
Max. torque at speed	1.7/6,500 Nm/rpm
Idling speed	2,800 rpm
Sound Pressure Level at the operator’s ear
at full load according to ANSI B 175.1	98 db(A)
Sound Pressure Level at the bystander’s position
(50ft/15 m distance) according to ANSI B 175.1	73 db(A)
Ignition system
Electronic, without breaker
Spark plug	NGK BPMR 7A
or Spark plug
Electrode gap	.020" (0.5 mm)
Fuel system
Carburetor (for Canada)	ZAMA
Carburetor (for USA)	ZAMA with limiter caps
(all position diaphragm carburetor
with integral fuel pump)
Fuel tank capacity	13.0 oz. (0.37 l)
Fuel mixture	see chapter "Fuel"
Weight
without cutting attachment	10 lbs. 5 oz. (4.7 kg)
Cutting attachment
Guide bar	sprocket nose bar
Cutting length	14" (35 cm) • 16" (40 cm)
Safety saw chain (pitch) 3/8"	(528 092 ...)
Drive link gauge	.050"
Chain sprocket	6 teeth
Chain lubrication	fully automatic oil pump
Oil tank capacity	8.8 oz. (0.25 l)

Approved bar and chain combinations

"Low-kickback saw chain is a chain which has met the kickback performance requirements of ANSI B 175.1- 1991 (American National Standard for Power Tools- Gasoline-Powered Chain Saws-Safety Requirements) when tested on the representative sample of chain saws below 3.8. C.l.D. specifed in ANSI B 175.1- 1991". The approved bar and chain combinations are low kickback chains according to ANSI B 175.1-1991 and also meet the kickback requirements of CSA Z62.3-96 for chain saws below 80 cm3.

The chain saw DCS 34 has been approved with following guide bar and chain combinations:

Drive link gauge .050"

	Guide bar 3/8"	Saw chain 3/8"
length	Part no.	Part no.
14" (35 cm)	442 035 661	528 092 652
16" (40 cm)	442 040 661	528 092 656

WARNING

Do not use other replacement bars and chains unless they have been designated as meeting the ANSI B 175.1-1991 (for USA) and CSA Z62.3-96 (for Canada) kickback performance requirements on that specific powerhead, or has been desig- nated as "low kickback" saw chain in accordance with the ANSI B 175.1-1991 (for USA) and CSA Z62.3-96 (for Canada) standard.

"There may be other replacement bar and chain combi- nations available that also reduces the risk of injury from kickback".

17