Repair | P 16/22 |
|
[3] DISASSEMBLY/ASSEMBLY
ASSEMBLING
1)Assemble Impact bolt section to Tool holder (guide) complete as drawn in Fig. 42.
Fig. 42
Note: The five components are directional, and must be mounted as shown below.
Tool holder (guide) complete | Ring 10 | O ring case with | |
Sleeve 9 | O ring 9 fit inside | ||
Impact bolt | Cushion ring 13 | ||
Bit (chuck) |
|
| Inner housing |
installation |
|
| complete side |
side |
|
|
|
long | short |
|
|
2)Push Ring spring 28 into the inner groove of Tool holder (guide) complete as drawn in Fig. 43.
Fig. 43
Note: 1) Use an extra Piston cylinder as a jig. Never use Piston cylinder that is to be assembled to the machine.
2)The end gap of Ring spring 28 must not be positioned in either of the two holes of Tool holder (guide) complete.
|
| Note: 1) |
|
Piston cylinder |
|
| Piston cylinder as a jig |
as a jig |
| Inner groove of | |
|
| ||
|
| Tool holder (guide) |
|
end gap |
| complete |
|
Ring spring 28 |
|
|
|
Tool holder | hole | Ring spring 28 | O ring case |
| |||
(guide) complete |
|
|
|
hole |
|
|
|
Note: 2)
[Correct] [Wrong]
Tool holder 
(guide) complete 
Ring spring 28 
end gap
