Repair | P 15/22 |
|
[3] DISASSEMBLY/ASSEMBLY
DISASSEMBLING
(1)When Striker is left in Tool holder (guide) complete, push Striker out of Tool holder (guide) complete by inserting 1R281 from the top end then by striking 1R281 with plastic hammer.
(2)Remove Tool holder (guide) section as instructed in
(3)Remove Ring spring 28 from Tool holder (guide) complete and disassemble Impact bolt section. (Figs. 38 to 41)
Fig. 38
Note:
If the end gap of Ring spring 28 is in the hole of Tool holder (guide) complete, slide it with a slotted screwdriver until it is completely hidden.
end gap of Ring spring 28 | Ring spring 28 | |||
|
|
|
|
|
Slotted | Tool holder (guide) complete |
screwdriver |
Fig. 39
Insert 1R249 into Tool holder (guide) complete from Inner housing complete side, then put it on arbor press table as drawn on the right.
Press down Tool holder (guide) complete using arbor press.
Using slotted screwdriver and plastic hammer,
tap Ring spring 28 through the two holes located on the opposite side to each other alternately to push the ring down out of the groove inside Tool holder (guide) complete.
[Cap 35 side]
Ring spring 28
Tool holder (guide) complete 
[Inner housing complete side]
[Cap 35 side]
[Inner housing complete side]
1R249
Fig. 40 | Fig. 41 |
Ring spring 28 can be pulled off from Tool holder (guide) complete when completely removed from the groove.
Note:
Be sure to replace Ring spring 28 when assembling Tool holder (guide) section.
Tool holder (guide) complete
Ring spring 28
Disassemble Impact bolt section by striking Tool holder (guide) complete against workbench.
Tool holder (guide) complete
Impact bolt section
Sleeve 9
Impact bolt
Ring 10
Cushion ring 13
O ring case with
O ring 9 fit inside
