Makita 6413 P 10/12, Machines With Choke Coil, Fig. D-4, Route Lead wires, between these ribs

P 10/12

Wiring diagram

Model 6411 (without Variable speed control and Reverse switch)

Machines With Choke Coil

Important: Do not put slack portion of any Lead wire in the space surrounded by Field and Brush holders. Otherwise Lead wires will be broken by rotating Armature.

Note: 1) Some countries do not use Noise suppressor.

2) Put Choke coils and Noise suppressor (if used) in place as illustrated in Fig. D-4.

Fig. D-4

Lead wires

Choke coil lead wire (purple) to Brush holder

Choke coil lead wire (purple) to No.1a Terminal of Switch

Choke coil lead wire (orange) to Brush holder

Choke coil lead wire (orange) to Field

Field lead wire (black) to No.2a Terminal of Switch

See "Connecting Lead wire to Brush holder".

Brush holder

Put slack portion of Lead wire in the space between Brush holder and inside wall of Housing (L). Otherwise the Lead wire will touch rotating Armature.

Fix two Lead wires with this Lead wire holder.

Choke coil

(with purple Lead wires)

boss A

boss B

See "Connecting Lead wire to Brush holder".

Field

Route Lead wires	Switch
between these ribs.
	Route Lead wires
	under Brush holder.
Choke coil
(with orange Lead wires)	Noise suppressor
	[if used]
	Power supply cord

Connecting Lead wire to Brush holder 1) Brush holders are not reversible

when assembled to Housing (L). Terminal insertion hole of each Brush holder must be positioned

outside boss A/boss B.

boss A

Terminal

Brush holder

2) Do not route each Lead wire

inside boss A/boss B.

boss B