Removing the Holder
Pulling out the Dark Slide of a
Detached Roll Film Holder
Insert the Dark Slide into the Roll Film Holder. For instant recognition, the Dark Slide Slot is bordered by white reference lines. The Film Holder can be removed after moving the Holder Lock Lever as far as it will go toward the Lock Release Lever “A”. It is recommended that you remove the holder on a table or similar support, or in your lap, to avoid the possibility of dropping the holder or having it fall off the camera.
If you attempt to remove the holder without replacing the Dark Slide, the Holder Lock Lever will automatically lock in place, preventing accidental removal of the holder and exposure of the film.
However, if you must remove the holder without the Dark Slide in place, the automatic lock can be overridden by pulling the Lock Release Lever toward the Holder Lock Lever, holding the lever there, and then moving the Lock Lever.
When detached from the camera body, the Dark Slide cannot be pulled out. However, if you wish to remove it, push in the pin “A” on the holder with a pointed object.
Note:
While all model RZ and RZ PRO II roll film holders can be used with both the RZ and RZ PRO II, this does not apply to the interchangeability of the film holder inserts. They can only be used with their respective roll film holder housings.
23
