![](/images/new-backgrounds/1312727/31272725x1.webp)
HINT: You should set the HDMI resolution to the highest that your television can display (see your television’s manual). If in doubt, set the resolution to 720p.
Enter your postcode using the number buttons on the remote control, or press the red button to use the
postcode, press the
button and then press
to proceed.
The signal check screen shows the strength and quality of the Freesat signal received from your satellite dish. If the signal lock fails, you should check the satellite dish connection at the back of the receiver (switch the receiver off and reconnect the cable if necessary). If the connection is OK, consult your dealer or installer.
When the signal lock is successful, press
to proceed.
HINT: Enter your postcode with the number buttons by pressing the correct button on the remote a number of times to produce the relevant letter (printed above each button), or number, in the same way as ‘texting’ with a mobile phone. For example, for an ‘S’, you would press the
7button four times. If you make a mistake, the button deletes the last character entered.
With the
13