Marantz LN-11S1A manual Setup

ADVANCED OPERATION

USING A PROGRAMMABLE REMOTE CONTROLLER

This unit can be controlled using a programmable remote controller (such as an RC9001 or RC2001). For commands used to control this unit, refer to the table at right. For details on programmable remote controllers, contact your Marantz dealer or Marantz Consumer Marketing.

RC5Operation

Command

00	56	15	Moves the anamorphic lens to the
			operating position.
00	62	01	Moves the anamorphic lens to the
			operating position.
00	56	20	Moves the anamorphic lens to the
			non-operating position.
00	62	02	Moves the anamorphic lens to the
			non-operating position.

FIXING THE ANAMORPHIC LENS POSITION

This unit is controlled according to the last signal input. When a 12V DC signal from the projector is input to the +12V TRIGGER IN jack of the unit, if the projector’s power is turned off and the 12V DC trigger signal is no longer input, the anamorphic lens moves to the opposite end from the operating position. To fix the anamorphic lens position, unplug the AC/DC adapter from the power outlet and stop the supply of power.

SETUP			USE
Mount and adjust the LN-11S1A according to the procedure described below.			BEFORE
Note:
The LN-11S1A enlarges projected images by approximately 1.3 times in the horizontal direction. When using			PARTS
the LN-11S1A in combination with a screen having a 2.35:1 aspect ratio, be sure to determine the installation
image may stick out beyond the left and right screen borders when using the LN-11S1A with a screen you already
location based on the screen size in the vertical direction. In addition, there is a possibility that the projected
own. In this case, be sure to change the projector’s zoom setting or its installation location. For details on the			OF
projector’s installation location, refer to the user’s guide included with your projector.			NAME
Ex.:
2.35:1 screen			OPERATION
			BASIC
Screen	When using an anamorphic lens	When not using an anamorphic lens

1.78:1 screen

I S

NOTES WHEN SIMULTANEOUSLY USING +12 V TRIGGER INPUT AND REMOTE CONTROLLER

This unit can be controlled using a +12V trigger input

Screen

COPERATIONNNEC

ADVANCED

When using an anamorphic lens When not using an anamorphic lens

in combination with a remote controller. In this case, the very last control is prioritized.

Ex.1) A 12V DC signal is input to the +12V TRIGGER IN jack and the anamorphic lens moves to the operating position. If AUX2 on the remote controller is pressed at this time, the anamorphic lens moves to the opposite end from the operating position.

Ex.2) The anamorphic lens is moved to the operating position using the remote controller. Even though nothing happens even if a 12V DC signal is input to the +12V TRIGGER IN jack at this time, when the 12V DC signal being input to the +12V TRIGGER IN jack is cut off, the anamorphic lens moves to the opposite end of the operating position.

For an example of the Screen Size and Projection Distance VP-11S2, VP-15S1, refer to the page 12.	SETUP
	TROUBLESHOOTING
	OTHERS

5