Marantz manual Mounting the LN-11S1A On the Ceiling

MOUNTING THE LN-11S1A

(ON THE CEILING)

Mount the assembled LN-11S1A and MOUNT20 to the projector. Refer to Figure 16.

Note:

Plate #4 supplied with the MOUNT20 is located in a separate shipping carton from the projector or LN-11S1A.

1. Spread a soft cloth on a stable, horizontal surface to protect against scratching, and carefully place the projector upside down on the cloth.

Align the mounting holes on the LN-11S1A base plate with the lens slider attached with the two ceiling mount kit mounting screw holes located on the lens side of the projector. Refer to Figures 16 and 17. Align one supplied 8-mm washer with the other ceiling mount kit mounting screw hole located on the projector unit. Gently place Plate #4, supplied with the MOUNT20, and attach securely at the two front locations using two M8x10 hexagonal head bolt supplied with the LN-11S1A and at the one rear location using one 8-mm screw supplied with the MOUNT20. Refer to Figure 17.

Figure 16

Mountina slits

Mounting hole

Figure 17

Figure 18

Notes:

•When the projector is combined with the ceiling mounting kit, the total weight is approximately 59 pounds (26.7kg). For safety, assembly should be performed by two or more people.

•Be sure to check the maximum weight that can be withstood by the ceiling before installation. Also, even if the weight that can be withstood is large enough, when installing in a location where people will pass directly below the projector, be sure to take measures against the projector from possibly falling through the use of wires or other means.

2. Lift and slide the projector onto the 1/4-20 inch screws previously installed in the metal studs of the plate on the ceiling (see arrow in Figure 19).

Tighten the 1/4-20 inch screws on both sides of the mount and install two 6mm screws and washers into the side of the projector Mounting Plate 4. Refer to Figure 19.

Projector side

20˚ tilt

Figure 19

3. It is important to completely finish mounting the projector and making initial settings before mounting and adjusting the LN- 11S1A anamorphic lens. Perform necessary procedures such as focus adjustment while referring to the projector’s user’s guide. Once the required projector settings have been made, proceed with lens mounting and adjustment.

SETUP

REMOTE CONTROLLER ADVANCED BASIC OTHERS TROUBLESHOOTING SETUPNAME OF PARTS BEFORE USE OPERATION OPERATION OPERATION

9